Scroll Saw: Difference between revisions
Jump to navigation
Jump to search
Created page with "Category: Tools Category: Power Tools ==Rikon 10" Bandsaw== This is a benchtop model bandsaw capable of sawing up to 4 5/8" stock. It can be used with 1/8" - 1/2" bl..." |
m edited safety procedures |
||
| (4 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
{{Stub}} | |||
== | [[Category:Tools]] | ||
[[Category:Power Tools]] | |||
[[Category:Requires Maintenance]] | |||
== Delta 16” Variable Speed Scroll Saw == | |||
[[:File:40540.pdf|Manual]] | |||
==Safety== | ==Safety== | ||
Use '''caution''' and '''common sense''' when using this tool. It will easily take your finger off | Use '''caution''' and '''common sense''' when using this tool. It will easily take your finger off. | ||
===Follow ALL safety procedures=== | ===Follow ALL safety procedures=== | ||
| Line 14: | Line 19: | ||
##Close the door of the tool room when operating the saw | ##Close the door of the tool room when operating the saw | ||
##Do not approach someone while they are using the saw. | ##Do not approach someone while they are using the saw. | ||
#Make sure blade is properly tensioned (see page 11 of manual). | |||
##Ensure the blade tension knob is in the rear position. | |||
##Turn blade tension knob clockwise to increase tension or counter-clockwise to decrease tension. | |||
#Adjust hold down foot for each new operation so it contacts the top of the stock/material being cut (see page 13 of manual). | |||
##Move the hold down rod up or down and tighten the lock handle. | |||
#Start the saw clear of material. Let it come up to full speed before engaging the blade. | #Start the saw clear of material. Let it come up to full speed before engaging the blade. | ||
#Always keep fingers at least 3 inches away from the blade. | #Always keep fingers at least 3 inches away from the blade. | ||
Latest revision as of 18:54, 1 February 2024
Delta 16” Variable Speed Scroll Saw
Safety
Use caution and common sense when using this tool. It will easily take your finger off.
Follow ALL safety procedures
- Secure loose hair and clothing.
- Wear safety goggles.
- Check and clear your perimeter before starting.
- Close the door of the tool room when operating the saw
- Do not approach someone while they are using the saw.
- Make sure blade is properly tensioned (see page 11 of manual).
- Ensure the blade tension knob is in the rear position.
- Turn blade tension knob clockwise to increase tension or counter-clockwise to decrease tension.
- Adjust hold down foot for each new operation so it contacts the top of the stock/material being cut (see page 13 of manual).
- Move the hold down rod up or down and tighten the lock handle.
- Start the saw clear of material. Let it come up to full speed before engaging the blade.
- Always keep fingers at least 3 inches away from the blade.
- Never guide the material with your hands or fingers in front of the blade.
- Only cut stock/material that is flat on the bottom.
- Your fingers should never be under the material.
- If you need to back the blade out, stop the saw and let the blade come to a complete stop before backing out.
- Let the blade come to a complete stop before clearing scrap material.